The procedure to register a tape library is as follows:
On the global navigation tab, click [Storage].
On the Category pane, click [Tape Library].
The registered tape libraries are displayed on the Main pane.
On the Action pane, click [Discover] under the [Tape Library].
The information input screen is displayed.
Enter the IP address and SNMP community name, and click the [Discover] button.
Confirm the information, and click the [Register] button on the lower right.
Note
An IP address that has been already used in the tape library registered in the ETERNUS SF cannot be specified.
The Web Console cannot set the SNMP Trap transmission place address for tape library. In the Web Console, the SNMP Trap setting checkbox is always grayed out. Therefore, it is necessary to set the SNMP Trap transmission place address on the tape library separately.
The registration processing of tape library may take from a few minutes to over 10 minutes depending on the device configuration. "4.21.1 Display the operation history" allows you to confirm the completion of tape library registration processing. The tape library registration processing has completed when the displayed items of the Operation History screen is as follows:
Action : Register Tape Library
State : Complete
Result : Success
Target : IP address of the registered tape library
Please do not perform any operation for this tape library until the registration processing has been completed.
