Refer to "A.4.1 System Parameter Tuning Values" below for the system parameters that require tuning, and their values.
Set values as shown below in accordance with the parameter "Type".
If the type is "Maximum":
If the value already set (initial value or previously set value) is greater than the value shown in the table, it need not be changed. If it is smaller than the value in the table, change it to the value in the table.
If the type is "Additional":
Add the value shown in the table to the value that is already set (initial value or previously set value). Check the system maximum values before adding this value and, if adding that value would exceed the system maximum value, set the system maximum value.
Refer to a Linux manual or similar for details.