2.2.4 Installation [Solaris]

This section explains the procedure for agent installation.

Before installing Resource Orchestrator, check that the preparations given in "2.2.1 Preparations" have been performed.

Log in to the system as the OS administrator (root).
Boot the managed server that agent (Cloud Edition for Dashboard) is to be installed on in multi-user mode, and then log in to the system using root.
Set the first DVD-ROM and execute the following command, then move to the directory where the installer is stored.
# cd DVD-ROM_mount_point/DISK1/Agent/Solaris/agent <RETURN>
Execute the agent installer (the rcxagtinstall command).
# ./rcxagtinstall <RETURN>
ServerView Resource Orchestrator V3.0.0
Copyright FUJITSU LIMITED 2007-2011

This program will install ServerView Resource Orchestrator Agent on your system.

The license agreement is displayed.

This program is protected by copyright law and international treaties.
Unauthorized reproduction or distribution of this program, or any portion of it,may result in severe civil and criminal penalties, and will be prosecuted to the maximum extent possible under law.

Copyright FUJITSU LIMITED 2007-2011

Do you want to continue the installation of this software? [y,n,?,q]

Check the content of the agreement, and enter "y" if you agree or "n" if you do not agree.

If "n" or "q" is entered
The installation is discontinued.
If "?" is entered
An explanation of the entry method is displayed.

Enter "y" and the installation will start.
Example
INFO : Starting Installation of ServerView Resource Orchestrator Agent...
INFO : Package FJSVrcxat was successfully installed.
...
When installation is completed successfully, the following message will be displayed.
INFO : ServerView Resource Orchestrator Agent was installed successfully.

Note

Corrective Action for Installation Failure
Execute the following command, delete the packages from the environment in which installation failed, and then perform installation again.
# cd DVD-ROM_mount_point/agent <RETURN>
# ./rcxagtuninstall <RETURN>
Nullifying Firewall Settings for Ports to be used by Resource Orchestrator
When installing Resource Orchestrator on systems with active firewalls, in order to enable the manager to communicate with agents correctly, disable the firewall settings for the port numbers to be used for communication.
For the port numbers used by Resource Orchestrator and required software, refer to "Appendix A Port List" of the "Design Guide CE".
However, when port numbers have been changed by editing the services file during installation of Resource Orchestrator, replace the default port numbers listed in "Appendix A Port List" of the "Design Guide CE" with the port numbers changed to during installation.