This software supports fault management for the Brocade VDX series.
Connecting to the Network
Make the required settings for the Brocade VDX series which you use to connect to a network, and then connect to the network.
For details on the setting method, refer to the manuals provided with the respective devices.
SNMP Trap Settings
Although SNMP Trap is used in fault monitoring, the SNMP Trap send destination address automatic settings function is not supported for Brocade VDX series.
In order for SNMP Trap to be sent to the Management Server, log in to the device, execute the following commands in the given sequence, and then set the SNMP Trap send destination address.
If the Management Server is defined as a cluster, the logical IP address of the cluster needs to be set.
switch# configure terminal switch(config)# snmp-server host [SNMP Trap send destination address] public version 1 udp-port 162 severity-level Warning switch(config)# exit |
For details on the setting method, refer to the manuals provided with the respective devices.
Registering the Device
Refer to "5.2.6 Registering a Manually Embedded Device" and "Register the storage device" in the "ETERNUS SF Web Console Guide", to register the virtual tape appliance device.
For the registration, set the following for the device:
Select "Other" for the product type and storage type
Enter "Brocade" in the manufacture name
Note
Use SNMP protocol version 1 for SNMP Trap received from Brocade VDX series.
Use the ping command for polling monitoring.
