This section describes how to execute Advanced Copy functions with command line interface.
See
For details on the commands, refer to "Commands" in the "ETERNUS SF Operation Guide for Copy Control Module".
Access volume settings
Create a volume to ETERNUS Disk storage system and assign it to the Management Server.
For details, refer to "Set the access volume" in the "ETERNUS SF Web Console Guide".
Registering ETRNUS Disk storage system
Using "acarray add" command, register an ETERNUS Disk storage system.
Set up the type of the connection with ETERNUS Disk storage system at the same time.
Note
For ETERNUS Disk storage system name specified with -a option of "acarray add "command, specify an ETERNUS Disk storage system name registered to Express.
If a different name is registered, Advance Copy using the Web Console is not available.
Creating copy groups
Using "acgroup create" command, create a copy group.
Adding copy pairs
Using "acpair add" command, add a copy pair to a copy group.
Executing copy
Execute copy, using the copy start commands prepared for each copy function.
Note
If the copy status or SID is "???" or "Unknown", an access volume may be wrong. Check the access volume with "acarray detail" command.
If the access volume is wrong, refer to "Set the access volume" in the "ETERNUS SF Web Console Guide" to set a correct access volume.
When changing the copy mode of remote copy (REC), suspend the copy with "acec suspend" command and then execute "acec change" command.
