Format
strhanet
Description
Activates all virtual adapters set using the hanetconfig command. If you use the adapter setting script to set IP addresses automatically, the script is executed automatically after you execute the strhanet command.
Notes
Once you have activated a virtual adapter, that adapter is activated automatically every time you start the system. Therefore, it is not necessary to activate it again.
Make sure that the network properties screen is closed before running this command. Otherwise, an error may occur in executing the command.
It may take about 30 seconds for each virtual adapter to be activated.
This command is not available in safe mode.
After running the strhanet command, unintended adapter names may be displayed. On refreshing the screen, it will display the correct list of adapter names.
Do not force termination of the strhanet command while it is running.
If such termination is unavoidable, run the stphanet command afterwards to deactivate the virtual adapters; then, run the strhanet command, and reboot the system.
After terminating the strhanet command, there may be cases that virtual adapters will be detected as new devices. In such a case, please install the GLS drivers on the device detection screen before carrying out this countermeasure.
Example
To activate all virtual adapters:
> strhanet |
