An event trap is a message that is sent from the device. For details on these messages, refer to the instruction manual for hardware, and take appropriate action.
Level | Event display | Failure event |
|---|---|---|
Information | ErrorCode=%1%, ErrorID=%2%, Node=%3%, FRU=%4%, Msg=%5% | An information event has occurred. |
Warning | ErrorCode=%1%, ErrorID=%2%, Node=%3%, FRU=%4%, Msg=%5% | A warning event has occurred. |
Error | ErrorCode=%1%, ErrorID=%2%, Node=%3%, FRU=%4%, Msg=%5% | An error event has occurred. |
Information
Character strings in the event display
The information shown in the table below is displayed in the event message for %n%.
%n% | Information |
|---|---|
%1% | Error code |
%2% | Error ID |
%3% | Node number identified by the event notification |
%4% | FRU information identified by the event notification |
%5% | Message |
When the event trap does not contain any corresponding information, "None" is displayed for %n%.
If there is no need for device maintenance and the notification does not indicate a device error, "None" is displayed for %1%.
When the notification is for the cluster overall and does not depend on a specific node, "None" is displayed for %3%.
Note
In the default setting, Information level messages are not displayed. To display Information level messages, refer to "SNMP Trap XML Definition File" in the "ETERNUS SF Storage Cruiser Operation Guide", and change the Information level setting.
