PRIMECLUSTER Wizard for NetWorker 4.2 Configuration and AdministrationGuide

3.1.2 Procedure for Autorestart Setup

Enable Autorestart function by the procedure below.

Note

• In case of NetWorker 7.2, you can use the NetWorker Administrator program (nwadmin) to enable the Autorestart function. For the nwadmin command, see the NetWorker manuals.

• In case of NetWorker 7.4/7.5/7.6, you can use the NetWorker Management Console to enable Autorestart function. For the NetWorker Management Console, see the NetWorker manuals.

Procedure

Follow the procedure below if you use the NetWorker Administrator program (nwadmin).

1. Ensure that the NetWorker server is running normally on the OPERATING node.

2. Login to the OPERATING node as superuser.

3. Start the NetWorker Administrator program (nwadmin):

4. Open [Group] window on [Customize] on menu bar.

5. Select [View] -> [Details] on [Group] window.

6. Change [Autorestart] to [Enabled].

   
   

Follow the procedure below if you use the NetWorker Management Console.

1. Ensure that the NetWorker server is running normally on the OPERATING node.

2. Select [Configuration] on [NetWorker Administration] screen of NetWorker Management Console.

3. Select [Groups] from left pane, then [Groups] list is displayed.

4. Right-clicks the group which enables Autorestart function and select [Properties], then properties are displayed.

5. Change [Autorestart] to [Enabled] on [Advanced] tab.

Note

• To enable Autorestart function, [Autostart] must be changed to [Enabled].

• If [Manual restart] is specified on [Options], [Autorestart] is not enabled.

• Note that if backup is interrupted, [Manual restart] on [Options] is automatically selected.