Pay attention to configure the following NetWorker settings.
Server Configuration
The following items must be defined for server that is specified as VirtualHost.
Follow the procedure below if you use the NetWorker Administrator program (nwadmin).
Start nwadmin GUI, and select [Server] -> [Server Setup].
Specify name of administrator of physical node that consists of cluster on [Administrator] field.
Follow the procedure below if you use the NetWorker Management Console.
Start NetWorker Management Console, and select [Configuration] on [NetWorker Administration] screen.
Select [File] -> [Properties].
Specify name of administrator of physical node that consists of cluster on [Administrator] field.
Example
user=root,host=clus_phys1 user=root,host=clus_phys2
Note
NetWorker server name is the logical node name set in the userApplication configuration.
If node name takeover of takeover network resource of PRIMECLUSTER is used, above setting isn’t necessary.
Client Configuration
Configure each physical node within the cluster as a NetWorker client.
Follow the procedure below if you use the NetWorker Administrator program (nwadmin).
Start nwadmin GUI, and select [Client] -> [Client Setup].
Confirm that the physical node name has been set in the [name] field. If it has not been set, click [create], and enter the physical node name for the [name] field.
Follow the procedure below if you use the NetWorker Management Console.
Start NetWorker Management Console, and select [Configuration] on [NetWorker Administration] screen.
When the client of the physical node name does not exist, create the new client.
Enter the physical node name for the [name] field.
Configure each logical node within the cluster as a NetWorker client.
Follow the procedure below if you use the NetWorker Administrator program (nwadmin).
Start nwadmin GUI, and select [Client] -> [Client Setup].
Confirm that logical node name has been set in the [name] field. If it has not, click [create], and enter the logical node name for the [name] field.
Enter the name of the administrator of each physical node that the logical node is activated in the [remote access] field.
Follow the procedure below if you use the NetWorker Management Console.
Start NetWorker Management Console, and select [Configuration] on [NetWorker Administration] screen.
When the client of the logical node name does not exist, create the new client.
Enter the logical node name for the [name] field.
Enter the name of the administrator of each physical node that the logical node is activated in the [Remote access] field on [Globals (2 of 2)] tab.
Example
user=root,host=clus_phys1 user=root,host=clus_phys2
Note
It is necessary to create the clients with the name of each physical node within the cluster to be backed up even if backing up by the physical node name is not done.
Do not register the physical node name in the "alias" attribute if backing up by the logical node name is done.
Client configuration of NetWorker needs to be done only to NetWorker server on the OPERATING node. After the configuration, switch the cluster system, and confirm that the configuration is effective on the STANDBY node. After the confirmation, switch the cluster system again.
