PRIMECLUSTER Wizard for NetWorker is a software product that facilitates cluster operation management for NetWorker operating on a PRIMECLUSTER system.
The standby operation requires NetWorker.
PRIMECLUSTER Wizard for NetWorker enables backing up and recovering integrated data on a shared disk on cluster system that is constructed on PRIMECLUSTER with clustering environment.
Operation that the NetWorker server cooperates with the cluster system is called "Server cluster operation". Operation that the NetWorker storage node cooperates with the cluster system is called "Storage node cluster operation". Operation that the NetWorker client cooperates with the cluster system is called "Client cluster operation".
Note
NetWorker 7.4/7.5/7.6 does not support the high available storage node in any cluster systems. Therefore, the storage node cluster operation is not supported for NetWorker 7.4/7.5/7.6.
Module structure
The modules for operating NetWorker on PRIMECLUSTER are as follows:
Environment setup Wizard | Environment setup tool to enable NetWorker operation on PRIMECLUSTER |
Detector | Module to monitor NetWorker |
Scripts | Control starting and stopping the NetWorker daemons |
Setup/operation command | Commands used to set up and operate |
Environment setup
The environment setup tool provides “NETWORKER” Wizard that generates userApplication in the environment configuration by executing the “hvw” command of PRIMECLUSTER RMS Wizard.
Monitoring
The detector monitors NetWorker.
Startup and stop control
Along with the state transition of a cluster system, scripts automatically start or stop NetWorker.
Setup/operation command
Provides the commands to collect troubleshooting information and Discontinue Monitoring Resources of NetWorker.
