This section explains the messages that are output or displayed when the commands for this product are executed.
Messages for the cims mgrctl command
Description
The execution user is not an administrator for the operating system.
Action
Perform the operation with administrator privileges for the operating system.
For Windows Server 2008, users with administrator privileges other than the Administrator user cannot execute commands with administrator privileges by starting [Command Prompt] from the [Start] menu.
Such users should perform operations after right-clicking on the [Command Prompt] item in the [Start] menu and then selecting [Run as Administrator] from the context menu to open a command prompt.
Description
The command cannot run because there is not enough memory.
Action
Check whether there is enough memory.
Close any unnecessary programs, and then try again.
Description
The filename file for this product does not exist.
Action
In either of the following cases, restore the whole system or reinstall this product.
- If the corresponding file has been deleted
- If the corresponding file has been deleted as a result of system failure or an error with the disk or file system
In all other cases, collect this message and the Investigation data, and contact Fujitsu technical support.
Description
The filename file for this product cannot be accessed.
Action
Collect this message and the Investigation data, and then contact Fujitsu technical support.
Description
An error has occurred with a command for the Manager.
Action
Detailed information about the message is indicated in the <detail> section.
Take action according to the content indicated in the <detail> section.
- If "registry access error" is indicated in the <detail> section
Use the following procedure to check whether the installation for this product (Cloud Infrastructure Management Software) has completed.
Select the [Start] - [Programs] or [All Programs] - [Fujitsu] - [Uninstall (middleware)].
- If "syscall=" is indicated in the <detail> section
Collect the message in question and the Investigation data, and then contact Fujitsu technical support.
Description
This command may already be executing.
Action
Wait until the command has executed, and then try again.
Description
An error has occurred with the command.
Action
- If this message was output after the command execution had been canceled using "Ctrl+C" or some other method, the command has been canceled normally, and there is no need to take any action.
In other cases, collect the message in question and the Investigation data, and then contact Fujitsu technical support.
