This software supports fault management (SNMP trap monitoring only) of the CS800.
Network settings
At the CS800, enter the network connection settings to connect to the network. Refer to the manual provided with the device for details.
SNMP Trap setting
Make the required settings on the CS800 so that SNMP traps of the CS800 will be sent to the operation management server.
If the operation management server is defined as a cluster, the logical IP address of the cluster needs to be set.
Registering the device
Refer to "5.2.6 Registering a Manually Embedded Device" and register the device.
IP address of CS800 must be set in "IP address" for the registration.
