The specifications of the physical server are displayed.
When "Automatic" or "Pool" is selected for "Physical Server", a hyphen ("-") will be displayed in each parameter.
Enter the name of the model to assign to the L-Server.
Select the physical server to assign to the L-Server.
When a "pool" is specified, a physical server of the same model as that specified for model will be assigned from the resource pool.
When a physical server is specified, the specified physical server will be assigned.
Specify the server redundancy to assign to the L-Server. To enable redundancy, select the "HA" checkbox.
If the "HA" checkbox is selected, the "Pool for Spare Server" selection list will be enabled.
In the "Pool for Spare Server" selection list, specify the server pool that the physical server to use for automatic switchover is registered in.
When a problem occurs on the physical server, recovery is performed by automatically switching to another physical server in the same resource pool that is operating normally.
It is necessary that spare servers are physical servers not configured as L-Servers.
For the details of conditions for switchover to spare servers, refer to the information regarding server switchover conditions in the "ServerView Resource Coordinator VE Setup Guide".
Entry is only possible when the server type is "Physical". Specify the virtual WWN obtained from the ServerView Resource Coordinator VE I/O Virtualization Option (hereinafter I/O Virtualization Option) and the address pool of the registered MAC address. VIOM will be used for blades, and HBA address rename for rack mount servers.
