This section explains the procedure for agent installation. If agents of ServerView Resource Coordinator VE have been installed, refer to "1.3.1 Software Organization".
When creating multiple L-Servers, with "physical" as the server type, by using cloning, it is possible to copy the OS installed on one L-Server, updates, Resource Orchestrator agents, and common software between servers to other L-Servers.
For details, refer to "5.1.1 Manual OS Installation".
Pre-Installation Preparation and Checks
Confirm the following prior to installing the agent:
Exclusive Software Checks
Check that the software listed in "1.3.2.3 Exclusive Software" and the agent of Resource Orchestrator have not been installed on the system.
Required Software Checks
Check that the software listed in "1.3.2.2 Required Software" has been installed on the system. If it has not been installed, install it before continuing.
Installation Folder and Available Disk Space Check
Decide the installation folder for Resource Orchestrator.
Note that folders on removable disks cannot be specified.
Check that there are no files or folders in the installation folder.
Check that the necessary disk space can be secured on the drive for installation.
For the amount of disk space necessary for Resource Orchestrator, refer to "1.3.2.4 Static Disk Space" and "1.3.2.5 Dynamic Disk Space".
Port Number
When Resource Orchestrator is installed, the port numbers used by it will automatically be set in the services file of the system. So usually, there is no need to pay attention to port numbers.
If the port numbers used by Resource Orchestrator are being used for other applications, a message indicating that the numbers are in use is displayed, and installation will stop.
In that case, describe the entries for the port numbers used by Resource Orchestrator in the services file using numbers not used by other software, and then start the installer.
For details on port numbers, refer to the information about setup in the ServerView Resource Coordinator VE Setup Guide.
Checking the Admin LAN and NIC Status
Decide the network (IP addresses) to be used for the admin LAN.
Check that the NIC used for communication with the admin LAN is enabled.
For details on the admin LAN, refer to the setup preparation information in the "ServerView Resource Coordinator VE Setup Guide".
Installation
Install the agent. The installation procedure is the same as for ServerView Resource Coordinator VE.
For details on how to install the agent, refer to the "ServerView Resource Coordinator VE Installation Guide".
Note
Nullifying Firewall Settings for Ports to be used by Resource Orchestrator
When installing Resource Orchestrator on systems with active firewalls, in order to enable the manager to communicate with agents correctly, disable the firewall settings for the port numbers to be used for communication.
For the port numbers used by Resource Orchestrator and required software, refer to the port number list in the "ServerView Resource Coordinator VE Setup Guide".
However, when port numbers have been changed during installation of Resource Orchestrator, change the port number settings according to the "ServerView Resource Coordinator VE Setup Guide".
