This section describes the procedure to start the Express Web GUI.
Note
Since the ETERNUS Web GUI and the ETERNUS CLI have a higher authority over ETERNUS configuration change functions than the Express Web GUI. Therefore, if you use the former two with the Express Web GUI at the same time, the Express Web GUI may terminate abnormally.
For example, while a configuration is being changed with the ETERNUS Web GUI, you cannot execute "6.5 Changing configuration" with the Express Web GUI.
Therefore, when you use the Express Web GUI, do not use the ETERNUS Web GUI and the ETERNUS CLI.
Make sure whether the Computer Browser service is started. (Only when the computer is joined to a Windows domain)
If the computer is joined to the Windows domain, the Computer Browser service should be started on the management server in order to use the Express Web GUI.
For this reason, make sure that the [Status] of the Computer Browser service is [Started] by clicking on [Control Panel] > [Administrative Tools] > [Services].
Point
The Computer Browser service on Windows Server 2008 is stopped by default.
Start the Express Web GUI.
Start the Web browser.
Use HTTPS communication and a port number, connect to Express Manager.
At this time, specify 9855 for the port number.
Example
https://aaa.bbb.fujitsu.com:9855/express/
Login.
Enter your username and password to log into the Express Web GUI.
In each environment, the following usernames are specified.
Local server: Local user
Domain member server: Local user and Domain user
Domain controller server (PDC/BDC): Domain user
Note
When specifying a domain user, specify it in "Domain-name\user-name" format.
Note
When a large number of volumes or copy pairs are created at one time, a timeout error may occur.
If a timeout error should occur, take some time before updating the screen. If the volumes or copy pairs have been properly created after screen update, no action is required. If not, reduce the number of volumes or copy pairs to be created at one time and re-execute the operation.
