2.2.2 Starting daemons while the operating system is active

When you want to start a daemon if starting the daemon has failed or after you stopped the daemon intentionally, perform the action explained below, on the appropriate server.

Storage Management Server and Storage Server

For details, see "Starting and Stopping Daemons" in the "ETERNUS SF AdvancedCopy Manager Operator's Guide" for the operating system of the target Storage Management Server and Storage Server.

Tape Server

To start daemons, execute the following commands as the root user.

# /opt/swstorage/bin/startacm
# /etc/init.d/FJSVswstm start
# /etc/init.d/initTSM start

Note

If you need to start the daemon on the Tape Server individually, you can start the daemon as follows.

In the case of the Communication Daemon
1. The following commands are executed at the command line.
  # ps -ef | grep stgxfws
  Confirm that the following is not displayed:
  /opt/FJSVswstf/bin/stgxfws Logical-Node-Name
  If the above message is displayed, the daemon has already started.
2. For environment variable SWSTGNODE, specify the name of the logical node on which the transaction is to be performed.
3. Start the Communication Daemon.
  For the daemon start command, see "11.6 Starting and Stopping Daemons".
In the case of daemons other than the Communication Daemon
Refer to "11.6 Starting and Stopping Daemons". A logical node name is set as an environment variable SWSTGNODE, and a daemon starting command is executed.