7.1 Hardware

Operation models

Installation devices must meet the following requirements:

A model that enables basic software to be loaded
Memory: 256 Megabytes or more

I/O devices

The I/O devices shown below are required to perform tape backups.

An AdvancedCopy Manager licence and appropriate cache table size settings are required. These settings vary for different devices, so check with your Fujitsu systems engineer.

Table 7.1 Hardware requirements
Device name	Remarks
ETERNUS DX60/DX80/DX90 ETERNUS DX410/DX440 ETERNUS DX8100/DX8400/DX8700 ETERNUS2000 model 100 or higher ETERNUS4000 model 100 or higher ETERNUS8000 ETERNUS3000 model 100 or higher ETERNUS6000 ETERNUS GR720/GR730/GR740/GR820/GR840	Any one is required. To use ETERNUS DX60/DX80/DX90, ETERNUS DX410/DX440, ETERNUS2000, ETERNUS3000, or ETERNUS4000, it must be connected to a LAN. In addition, to use ETERNUS3000 models 100, 200, 400 and 600, its firmware version must be V20L32 or later.
ETERNUS LT20/LT40/LT60/LT130/LT160/LT220/LT230/LT250/LT270	Any one is required.
LAN card	None
Host bus adapter	An adapter that supports connection to a Fiber Channel Guard or similar storage (ETERNUS) device.

Note

LTO-Ultrium4 version drives cannot read LTO-Ultrium1 version tapes.
Make sure the tape version is compatible with the drive version.