PRIMECLUSTER Wizard for NAS (PRIMEQUEST) 4.2 Configuration and Administration Guide - Linux -

4.1 hvnasdisable - Discontinue monitoring resource

User

Super user

Format

/opt/FJSVclnas/sbin/hvnasdisable application_name resource_name

/opt/FJSVclnas/sbin/hvnasdisable -a [ application_name ]

Function

hvnasdisable discontinues monitoring Netapp resources specified on a local node where this command is executed.
This function is used to stop NAS devices for maintenance. If the command is executed while userApplication is running, the function is disabled to monitor the Netapp resources immediately, and the resource state enters the Warning state. Even though the NAS device is stopped, the resources remain Warning.
If hvnasdisable is executed while userApplication is stopped, it is necessary to confirm if the resource state is Warning, and then stop the NAS device for maintenance.

Parameter

application_name resource_name
Specify the name of userapplication with resources that discontinue to be monitored.
resource_name
Specify the name of Netapp resources that discontinue to be monitored
Both names should be available on a local node.

-a [ application_name ]
Disables monitoring all the Netapp resources of userApplication that is available on a local node, and is specified in application_name.
If it is not specified, hvnasdisable will only stop monitoring all the Netapp resources on the local node.

Exit status

0 : Normal termination
1 : Abnormal termination
2 : Abnormal termination (fails to stop monitoring resources with the -a option)

• Do not execute this command while switchover or failover is in progress.
• In standby operation and not using control facility for the NAS-Cluster, Netapp resource does not goes into Warning state.
• In using control facility for the NAS-Cluster, execute the hvnasdisable command to all Netapp resource.