ServerView Resource Coordinator VE Setup Guide

3.1.4 Chassis Settings (Settings for PRIMERGY Partition Models)

Choose values for the following management board settings, given the following criteria:

Chassis name

This name is used to identify the PRIMERGY Partition Model chassis on the admin server. Each chassis name must be unique within the system.
The first character must be alphabetic, and the name can contain up to 10 alphanumeric characters and hyphens ("-").

Admin IP address (Virtual IP address of the management board)

The IP address must be in the same subnet as the admin server.

User name

Name of the user account used to log into remote server management and gain control over the managed server.
A user account with at least administration privileges within the remote server management must be specified.
This user name must be between 8 and 16 alphanumeric characters long.

Password

Password used to log in the remote management controller with the above user name.
This password must be between 8 and 16 alphanumeric characters long.

SNMP community name

This community name can contain up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").

SNMP trap destination

Set the admin server IP address.

Note

To enable server switchover and cloning between servers in different chassis, use the same SNMP community for each chassis.