This section describes how to configure LAN switch blades for Resource Coordinator VE.
LAN Switch Settings
LAN switch blades
Refer to the LAN switch blade manual to apply the following settings.
VLAN IDs for the ports used to communicate with the Admin Server, as chosen in "3.2.1 Network Configuration"
Settings chosen in "3.2.4 LAN Switch Settings"
VLAN settings for other switch blade ports can be set from the RC console.
Refer to "6.2.1 Configuring VLANs on LAN Switches" for details.
However, settings other than VLAN settings should be made directly on the switch blade.
After setting up a LAN switch blade, perform a backup of the LAN switch blade's configuration. Refer to the manual of the LAN switch blade used for details how to backup of a switch blade.
LAN switches other than LAN switch blades
Refer to the LAN switch manual to apply the settings chosen in "3.2.4 LAN Switch Settings".
Note
Resource Coordinator VE uses telnet to log into LAN switches and automate settings.
Some models may restrict the number of simultaneous connections. In this case, log out from other telnet connections.
