Top
ETERNUS SFAdvancedCopy Manager 14.0 Operator's Guide forCluster Environment

2.1.3 How to install the Tape Manager function

This section explains the procedure for installing the Tape Manager function.

Note

Do not install the Tape Manager on the shared disk.

  1. Install and customize either the Manager or Agent function on the primary node.

    For details, refer to "Chapter 2 Installation of AdvancedCopy Manager".

  2. Install the Tape Manager function on the primary node.

    For details, refer to the "ETERNUS SF AdvancedCopy Manager Installation and Setup Guide", section "Installation of Tape Manager".

  3. Install and customize either the Manager or Agent function on the secondary node, using the same procedure as for the primary node.

  4. Install the Tape Manager function on the secondary node, using the same procedure as for the primary node.

The procedure for configuring environment settings for the Tape Server is described below.

  1. Perform tape server customization on the primary node.

    For details, refer to the "ETERNUS SF AdvancedCopy Manager Installation and Setup Guide" , section "Customization of Tape Server", sub-sections "Customization of Storage Server or Storage Management Server", "Creation of Access Path Partition", "Configuring the Port Number", "Kernel Parameter Tuning", and "TSM Configuration".

    Note

    Do do not perform the procedure described in the "ETERNUS SF AdvancedCopy Manager Installation and Setup Guide", section "Customization of Tape Server" > "TSM Configuration" > "Configuration of a Tape Library System".

  2. Perform tape server customization on the secondary node, using the same procedure as for the primary node.

Restart both nodes after the installation and customization procedures are complete. To build a cluster for tape server transactions, proceed as described in "Chapter 3 Preparations for Customizing Storage Management Server Transactions, Storage Server Transactions, and Tape Server Transactionss".