7.1 Hardware

Operation models

Installation devices must meet the following requirements:

A model that enables basic software to be loaded
Memory: 256 Megabytes or more

I/O devices

The I/O devices shown below are required to perform tape backups.

An AdvancedCopy Manager licence and appropriate cache table size settings are required. These settings vary for different devices, so check with your Fujitsu systems engineer.

Table 7.1 Hardware requirements
Device name	Remarks
ETERNUS DX60 ETERNUS DX80 ETERNUS GR720 ETERNUS GR730 ETERNUS GR740 ETERNUS GR820 ETERNUS GR840 ETERNUS2000 model 100 or higher ETERNUS3000 model 100 or higher ETERNUS4000 model 100 or higher ETERNUS6000 ETERNUS8000	Any one is required. To use ETERNUS DX60/DX80, ETERNUS2000, ETERNUS3000, or ETERNUS4000, it must be connected to a LAN. In addition, to use ETERNUS3000 model 100/200/400/600, its firmware version must be V20L32 or later.
ETERNUS LT130 ETERNUS LT160 ETERNUS LT220 ETERNUS LT230 ETERNUS LT250 ETERNUS LT270	Any one is required.
LAN card	None
Host bus adapter	An adapter that supports connection to a Fiber Channel Guard or similar storage (ETERNUS) device.

Note

LTO-Ultrium4 version drives cannot read LTO-Ultrium1 version tapes.
Make sure the tape version is compatible with the drive version.