Phenomenon
One of the following types of trouble occurs while using the storage migration function:
The "Monitoring Status" of the CA port in the storage device is "timeout".
The CA port of the storage device is not displayed.
The Fibre Channel card (HBA) of the server node is not displayed.
The access path is not displayed.
The access path is displayed incorrectly.
The physical line is not displayed.
The physical line is displayed incorrectly.
The "Same WWPN already exists" message is displayed in the event log.
The dialog box of "swsag0255" message is displayed.
Action
Do not perform operations with this software while using the storage migration function, because of the device information may not display correctly. If the device information does not display correctly, take the following action:
Delete the storage device that is using the storage migration function.
Clear the storage migration function settings.
Register the storage device that was deleted in step 1 again.
After the storage device has been registered again, re-configure the access path settings if the access path is "Config miss match".