This software supports all functions of the LT270, LT250 and LT160 except performance monitoring. Note that this software does not have a function to automatically detect LT270, LT250 and LT160 devices. The LT270, LT250 and LT160 devices can be detected by specifying their IP addresses for Device Search.
Connection to a network
Make the settings to connect the LT270, LT250 and LT160 to a network, and then connect the devices to the network. At the same time, start up the SNMP Agent function. For details of how to make these settings, refer to the manuals supplied with the LT270, LT250 and LT160 devices.
Setting Community for SNMP Environment setting
Select "public" as the Community name (GET). The Community name can be changed as desired. To change the Community name, see "Appendix C Customization".
Name (SysName) of a device for SNMP (Agent) Environment setting
Specify a nickname for the LT270, LT250 and LT160 device for management purposes. This software uses Sysname for said nickname value.
SNMP Trap setting
Manager does not add the SNMP Trap transmission place that was set at the device's registration to the device. Therefore, use the LT270, LT250 and LT160 Management Software to specify the SNMP Trap transmission place as the IP address of the administrative server on which this software runs. When the administrative server is defined by a cluster, the logical IP address of the cluster must be specified.
Setting and displaying an access path
This software does not use the HostAffinity setting of the LT270, LT250 and LT160, but displays access paths by using SwitchZoning or StorageAffinity of the server node.