PRIMECLUSTER Wizard for Oracle Configuration and Administration Guide 4.2 - Linux for Itanium -

4.2 hvoraenable - Restart Monitoring Resources

User

Super user

Format

/opt/FJSVclora/sbin/hvoraenable userApplication Resource
/opt/FJSVclora/sbin/hvoraenable -a [ userApplication]

Function

hvoraenable restarts monitoring the Oracle instance and Oracle listener resources on the local node where resource monitoring is disrupted. It is available regardless of whether userApplication is activated or deactivated.

If the command is executed while userApplication is stopped, disabling resource monitoring with hvoradisable will be cancelled. .

If the command is executed while userApplication is running, it will restart resource monitoring.

The command must be executed after the Oracle instance and Oracle listener are started manually. Be sure to check the resource state is changed from Warning to Online.

The ASM instance resource is and Oracle Clusterware resource are not monitored, so it is not necessary to cancel resource monitoring for them with the command.

For further details about ASM instance resources, refer to "2.4.2 ASM (Automatic Storage Management)".

Parameter

userApplication Resource

Specify userApplication including Oracle resources that will be disrupted monitoring for userApplication.
Specify either of the Oracle instance or Oracle listener that will be disrupted monitoring for Resource.
Specify all the resources them on the local node.

-a [userApplication ]
The option restarts monitoring all Oracle instance and Listener resources that belong to userApplication that is running on a local node and is specified for userApplication.

If userApplication is omitted, the option will restart monitoring all the Oracle resources on the local node.

Exit status

0: Normal termination

Non-0: Abnormal termination

2: Abnormal termination (disruption of resource monitoring with the -a option fails)

Note that execution timing. Unexpected resource failure or userApplication failover might be caused.

• Do not execute the command while state transition of userApplication is in progress.
• Please do not start of userApplication and do not stop immediately after the execution of this command (Please put for about five seconds).
• The Oracle instance and the listener must start manually before executing this command while the watch is interrupting when the manual operation has stopped.
• By the following, It can be confirmed that monitoring is restart by the hvoraenable command became effective
  • -The message of "INFO: 0102: Fault Watching is enabled" was output to syslog.
  • -The resource state enters Online.
  • -The results of clorainfo -m enters enable.