| PRIMECLUSTER Wizard for Oracle Configuration and Administration Guide 4.2 - Linux for Itanium - |
|
Contents
|
| Chapter 2 Environment Setup |
This section explains a general setup procedure of Oracle operating on a PRIMECLUSTER system.
|
No. |
Procedure |
|
|
operating node |
Standby node |
|
|
1 |
Install and configure PRIMECLUSTER |
Install and configure PRIMECLUSTER |
|
2 |
Install PRIMECLUSTER Wizard for Oracle |
Install PRIMECLUSTER Wizard for Oracle |
|
3 |
Install and configure Oracle software |
Install and configure Oracle software |
|
4 |
Create userApplication |
- |
|
5 |
Create and set up an Oracle database |
- |
|
6 |
- |
Set up an Oracle database |
|
7 |
Create and set up Oracle resources |
- |
For details, refer to"2.2 Standby Operation".
|
No |
Procedure |
|
|
One arbitrary node |
Other nodes |
|
|
1 |
Install and configure PRIMECLUSTER |
Install and configure PRIMECLUSTER |
|
2 |
Install PRIMECLUSTER Wizard for Oracle |
Install PRIMECLUSTER Wizard for Oracle |
|
3 |
Install and configure Oracle software |
Install and configure Oracle software |
|
4 |
Create and set up an Oracle database |
- |
|
5 |
Create and set up Oracle resources |
- |
For details, refer to"2.3 Oracle RAC 10g Scalable Operation".
The setup procedure explained in section "2.2" and "2.3" assumes that the userApplication will be created newly. In the case of upgrading from previous version, refer to "Installation Guide for PRIMECLUSTER Wizard for Oracle".
|
Contents
|