Chapter 3 Device Polling Event

When the device polling function of this software detects the state change of the device, display it in the event as follows.

Event	Level	Event display	Troubleshooting
When the state changes into error(red)	Error	Unit status changed: Error	Please confirm the state of the device.
When the state has changed warning(yellow)	Warning	Unit status changed: Warning	Please confirm the state of the device.
When the state has changed normal(green)	Information	Unit status changed: OK	None.
When the State has changed unmonitored	Warning	Connection Timeout	Please confirm whether the LAN between Manager and the device is operating normally. Please confirm whether the state of each device is proper, processes for network communication such as SNMP are operating, and when the device contains the server node Agent then the Agent is operating normally. If the community name of a device that uses SNMP for communication is changed, set the "SNMP_COMMUNITY_NAME_FOR_IP" to the setting file by referring to "C.2 sanma.conf Parameter" in the ETERNUS SF Storage Cruiser User's Guide, and reflect the contents of the setting file on this software.
When error occurs in the polling function	Error	[Polling] (Error event)	Take appropriate action for each event message as follows: Command could not be executed: <command name> This event occurs when command processing fails to start because of a resource shortage on the administrative server. If it is a temporary event, no special action need be taken. If it occurs regularly, however, check whether system resources (memory and file descriptors) on the administrative server have been depleted. XML File can not read: <file name> This event occurs when reading of the XML definition file fails. Check for an error in the definition contents. XML File not found: <file name> This event occurs when there is no XML definition file. Check for the file in the correct directory, which is specified by the directory path. Other Collect the message and other information for an investigation, and contact your Fujitsu certified service engineer.

When the state changes from unmonitored into the monitored, display the following events by the communication system of the polling function.

Device which uses SNMP
The above-mentioned event is displayed according to the newest state.
Device which uses except SNMP
The above-mentioned event is displayed according to the state before it is not possible to communicate.
For instance if the communication recovers when the state before it is not possible to communicate is warning (yellow), "Unit status changed: Warning" is output as an event.

See

For information about this event of ETERNUS VS900 Virtualization Switch, refer to "Fault Management" of "4.2.2.2 Points of concern" in the ETERNUS SF Storage Cruiser User's Guide.