| PRIMECLUSTER Global File Services Configuration and Administration Guide 4.1 (Solaris(TM) 10 Operating System) |
|
Contents
Index
|
| Appendix A List of Messages | > A.6 The GFS Shared File System Management View Messages |
The active file system cannot delete or change.
Unmount the file system, and do again.
Specified file system has error status.
Investigate the cause of abnormalities by reference of a Log.
The update log area is too small.
Change partition configuration to get enough update log area, and press <Next> or <Create> button.
The input mount point is not available.
Change the mount point, and press <Next> button.
There is no disk shared by the specified node.
Please change the selection of the node.
There are no unused disks.
None.
You cannot create a management partition because all the disk volumes are being used.
Re-execute the operation after you add a new shared disk and then set up the GDS logical volume. For information on making additions and performing setup, see the "PRIMECLUSTER Global Disk Services Configuration and Administration Guide (Solaris(TM) Operating System)"
A node cannot be added because it is out of the scope of the volumes that are set to the management partition.
Register the node in the scope of the management partition volume then execute the command again. For information on how to register a node with the scope, see the "PRIMECLUSTER Global Disk Services Configuration and Administration Guide (Solaris(TM) Operating System)".
If a GFS Shared File System is being started, you cannot change the configuration of the management partition.
Unmount all GFS Shared File Systems that are being started.
|
Contents
Index
|