| PRIMECLUSTER Global File Services Configuration and Administration Guide 4.1 (Solaris(TM) 10 Operating System) |
|
Contents
Index
|
| Appendix A List of Messages | > A.2 The GFS Shared File System Daemon messages |
This section explains the sfcfs_mount command messages that is called sfcfsd daemon of the GFS Shared File System.
The mounting failed due to a memory allocation failure.
Check the system status and wait for the termination of another process or increase the swap space, and re-execute the command.
The mounting failed due to an internal error.
Collect a file output with fjsnap for troubleshooting information then contact your customer support engineers.
The file system monitoring mechanism is not operating.
Check whether the file system monitoring mechanism is running.
The specified partition (special) does not exist in the file system configuration information.
Check whether the specified partition is correct.
Reading the file system configuration information failed.
Collect a file output with fjsnap for troubleshooting information then contact your customer support engineers.
The port number definition used in AC-to-MDS communication is not found.
Review the port number definition in /etc/services.
The host name information for AC-to-MDS communication cannot be obtained.
Review the host name definition in /etc/hosts, or change the host name with sfcadm(1M).
Creating a directory failed.
Take action according to errmsg.
The mounting fails because it has already been mounted.
Check whether the mounting has not been done with mount(1M), and take action.
The mounting cannot be performed because recovery processing is in progress.
None.
AC cannot connect to MDS. Therefore, mount the file system will be failed.
Check MDS down. In this case, try mount again.
The sfcfs module has not been loaded.
Check whether the sfcfs module has been loaded.
An unexpected error was detected on the mounting.
Check whether special and mountpoint actually exist. When it does not exist, it is possible that the specification of a directory or a file is error, or the directory of mountpoint is not created.
When an error is in specification, please specify the correct file and directory.
Please create a directory, when the directory of mountpoint is not created.
When each of the file and the directory exists, the host name of the sharing node of the relevant file system may not be a thing on the same network. Please confirm host name of the node information with the sfcinfo(1M) command with -an option.
Please re-execute mount_sfcfs(1M) after changing into the host name on the same network by the sfcadm(1M) command with -u option, when the specification host name is wrong.
And also, this message may be output when sharing node has failed. In that case re-execute mount_sfcfs(1M).
When unsolvable by the above methods, collect the diagnostic data with fjsnap, and contact your local Customer Support.
For details on sfcinfo(1M),sfcadm(1M), see sfcinfo(1M), sfcadm(1M).
An unknown error was detected.
Collect a file output with fjsnap for troubleshooting information then contact your customer support engineers.
Opening of the partition (special) failed.
Take corrective action according the detailed information errmsg.
Reading of the super block information or partition configuration information on the partition (special) failed.
Collect a file output with fjsnap for troubleshooting information then contact your customer support engineers.
The specified partition (special) is not of the GFS Shared File System.
Specify a special file that is being used for the GFS Shared File System.
|
Contents
Index
|