PRIMECLUSTER Global File Services Configuration and Administration Guide 4.1 (Solaris(TM) 10 Operating System)
Contents Index PreviousNext
Chapter 12 File System Management> 12.5 How to set GFS Shared File System applications as cluster applications

12.5.5 Setup flow chart of adding file data partitions to GFS Shared File Systems of cluster applications

The following setup flow chart shows how to add file data partitions to GFS Shared File Systems of cluster applications.

[Table The flow chart of adding file data partitions to GFS Shared File Systems of cluster applications]

Common operation
(to be executed on node A)

Node A (active node)

Node B (standby node)

-

Stop RMS.
(See "Procedure 1" in "12.5.6.")

Stop RMS.
(See "Procedure 1" in "12.5.6.")

-

Add a shared disk device as the GDS volume.
(See "Procedure 2" in "12.5.6.")

Add a file data partition to the GFS Shared File System.
(See "Procedure 3" in "12.5.6.")

-

-

Start RMS.
(See "Procedure 4" in "12.5.6.")

Start RMS.
(See "Procedure 4" in "12.5.6.")
Contents Index PreviousNext
All Rights Reserved, Copyright(C) FUJITSU LIMITED 2006