Interstage Shunsaku Data Manager Operator's Guide - Microsoft(R) Windows(R) 2000/ Microsoft(R) Windows Server(TM) 2003 - - UNIX -

8.3.3 Setting Up Shunsaku

This section explains how to set up Shunsaku.

Setting Up the Director Server

Set up the director server on the active server.

Setting up the director server is the same as the normal setup procedure, except for the following points:

• Editing the system environment file
• Editing the director environment file
• Copying environment files

If the operation mode for the failover is the N:1 active/standby configuration, the setup procedure is the same as for director servers.

Refer to Installing and Setting Up Additional Director Servers in the Installation Guide for more information on the setup procedure.

Editing the System Environment File

Specify the inherited IP address of the director server in the following execution parameters in the system environment file.

• Conductor
• Director
• Sorter

Editing the Director Environment File

Director data files and operation log files must be stored on shared disks.

Specify a directory on a shared disk for the following execution parameters in the director environment file.

• DataFileFolder
• OperationLogFolder

• If director data files and operation log files are damaged at the same time, the latest data cannot be recovered.
• Specify different shared disks for the locations of the operation log files and the director data files.

Copying Environment Files

For each environment file, the same settings must be used for the active server and the standby server. After the setup for the active server is complete, copy the following environment files over to the standby server.

• System environment file
• Conductor environment file
• Director environment file
• Sorter environment file

• After copying the system environment file, ensure that the content of the following 'services' file on the standby server is the same as the system environment file that has been copied.

  Windows installation folder\system32\drivers\etc\services

• If the direct access function is used, the direct access key definition file also has to be copied.

Setting Up Search Servers

The procedure for setting up search servers is the same as for normal (non-cluster) systems.

Refer to Installing and Setting Up Additional Search Servers in the Installation Guide for more information on the setup procedure.