G.2.5 Operation Procedures and Displayed Items for Cluster Application Setup and Modification

PRIMECLUSTER Installation and Administration Guide 4.2 (Linux for Itanium)

The procedures and displayed items for creating userApplications and for creating and changing procedure resources have been changed.

1. Creating a userApplication for standby operation

Before upgrading

To create a userApplication for standby operation, select "CRM" from the "Application type selection menu."
After upgrading

"CRM" is not displayed in the "Application type selection menu."

To create a userApplication for standby operation, select "STANDBY" from the "Application type selection menu."

2. Creating a userApplication for scalable operation

Before upgrading

To create a userApplication for scalable operation, select "Controller" from the "Application type selection menu."
After upgrading

"Controller" is not displayed in the "Application type selection menu."

To create a userApplication for scalable operation, select "SCALABLE" from the "Application type selection menu."

3. Creating a procedure resource

Before upgrading

To create or change a procedure resource, select "CRM" from the "turnkey wizard CRM" menu, and then select the resource class name.

Note: Shown below is an example of registering a procedure resource of the BasicApplication class to a userApplication.
After upgrading

The "turnkey wizard CRM" menu is not displayed.

To create or change a procedure resource, select "Procedure:resource-class-name" from the "turnkey wizard STANDBY" menu.

Note: Shown below is an example of registering a procedure resource of the BasicApplication class to a userApplication.

4. Changing the timeout value of a procedure resource

Before upgrading

To change the timeout value, select "Flags[0]=OTtimeout-time" and then select "SCRIPTTIMEOUT."
After upgrading

"Flags[0]=OTtimeout-time" is not displayed.

To change the timeout value, select "TIMEOUT."

5. Changing the priority in a resource class of a procedure resource.

Before upgrading

To change the priority in a resource class, select "Priority[0]=priority."
After upgrading

"Priority[0]=priority" is not displayed.

To change the priority in a resource class, select "PRIORITY."

None.