| PRIMECLUSTER Installation and Administration Guide 4.2 (Linux for Itanium) |
|
Contents
Index
|
| Part 2 Installation | > Chapter 5 Building a Cluster | > 5.1 Initial Cluster Setup | > 5.1.2 Setting Up the Shutdown Facility |
Check the information of the shutdown agent to be used.
Check the shutdown agent information before cluster initialization.
MMB check itemsIf an MMB
is being used, check the following settings:
The "Privilege" setting of the user is set to "Admin" so that the user can control the MMB with RMCP.
The "Status" setting of the user is set to "Enabled" so that the user can control the MMB with RMCP.
Check the settings for the user who uses RMCP to control the MMB. Log in to MMB Web-UI, and check the settings from the "Remote Server Management" window of the "Network Configuration" menu.
If the above settings have not been set, set up the MMB so that the above settings are set.
Jot down the following information related to the MMB:
User's name for controlling the MMB with RMCP (*1)
User's password for controlling the MMB with RMCP.
*1) The user must be granted the Admin privilege.
The MMB units have two types of users:
User who controls all MMB units
User who uses RMCP to control the MMB
The user to be checked here is the user who uses RMCP to control the MMB. Be sure to check the correct type of user.
For information on how to set up the MMB and check the settings, refer to the "PRIMEQUEST 480/440 Reference Manual: GUI/Commands."
|
Contents
Index
|