| PRIMECLUSTER Installation and Administration Guide 4.2 (Linux) |
|
Contents
Index
|
| Appendix A PRIMECLUSTER System Design Worksheets |
This section shows design examples of the PRIMECLUSTER system. Refer to these examples when designing the PRIMECLUSTER system.
System configuration
Note: The NTP server should be set to one of the following operation mode;
Maintains time that is reliable for special hardware devices such as time units and GPS units.
Uses another server that maintains time that is reliable for special hardware devices such as time units and GPS units, and uses NTP for time synchronization.
Used hardwarePRIMERGY TX600 x 2
LAN card x 4
Fibre channel card x 4
Disk array unit (ETERNUS3000 model100) x 1
Used softwareRed Hat Enterprise Linux AS (v.4 for x86)
PRIMECLUSTER 4.2A00
ETERNUS Multipath driver
MicroSoft Internet Explorer 6.0 (installed in the operation management personal computer)
JRE 1.4.2_08 (installed in the operation management personal computer)
Shared disk array settings|
Device name: ETERNUS3000 model100 (FC) |
Number of LU |
Number of RAID groups |
RAID level |
Size |
|
4 |
1 |
5 |
584GB |
A.11.1 Cluster Configuration Worksheet A.11.2 GFS Shared File System Setup Worksheet A.11.3 GLS Setup Worksheet A.11.4 GDS Configuration Worksheet |
Contents
Index
|