PRIMECLUSTER Installation and Administration Guide 4.2 (Linux)

8.7.2 Deleting the Hardware Resource

This section explains how to delete the resources of the following hardware.

• Shared disk device

• Network interface card

Procedure

1. Stop RMS.

   If RMS is activated, stop RMS as explained in "Stopping RMS."

2. Delete the hardware resource.

   Use "cldelrsc" command to delete the hardware resource that was registered.

   See the relevant manual pages for details on this command.

• If you have deleted an available network interface card by mistake, reregister the resources for the accidentally deleted network interface card by executing the "clautoconfig" command.

• If you have deleted other than the correct network takeover resource, reregister the deleted network takeover resource. See "Associating Resources to a Cluster Service Instance."

• If the shared disk for which resources are to be deleted is registered to a GDS class, first delete the shared disk from the GDS class, and then delete the resources of the shared disk. For instructions on how to delete a shared disk from a GDS class, refer to the "PRIMECLUSTER Global Disk Services Configuration and Administration Guide."