| PRIMECLUSTER Global File Services Configuration and Administration Guide 4.2 (Solaris(TM) Operating Environment) |
|
Contents
Index
|
| Appendix E List of Messages | > E.6 General Command messages Specific to GFS Shared File System |
The specified file is not on the GFS Shared File System.
Create a file on the GFS Shared File System.
Failed to create the specified file.
Re-execute the command after removing the cause of failure to create file referring to errmsg.
Failed to issue an fstatvfs(2) system call to the specified file.
Re-execute the command after removing the cause of failure of the fstatvfs(2) system call to file referring to errmsg.
Failed to set extent information of the specified file.
Re-execute the command after removing the cause of failure by referring to errmsg. Failure may have resulted from either of the following causes:
If contig is not specified:
- The area for init-blocks could not be acquired.
In this case, re-execute the command after deleting unnecessary files, specifying another GFS Shared File System, or adding a data area.
If contig is specified:
- A contiguous area for init-blocks could not be acquired (if inc-blocks are 0.)
- A contiguous area for init-blocks could not be acquired in inc-blocks.
- When init-blocks are not a multiple of inc-blocks, a contiguous area for the fraction could not be acquired.
In these cases, take the following actions:
- If 0 is set to inc-blocks, examine the value of init-blocks.
- If any value other than 0 is set to inc-blocks, decrease the value specified to inc-blocks. If the area still cannot be acquired, re-execute the command after deleting unnecessary files, specifying GFS Shared File System, or adding a data area.
The specified file already exists.
Check whether the specified file is correct. To recreate file, delete it before retrying.
|
Contents
Index
|