Machine Administration Guide 2.6

4.24 scfmail (1M)

NAME

scfmail - configures XSCF mail report

SYNOPSIS

/usr/sbin/FJSVmadm/scfmail {enable|disable}
/usr/sbin/FJSVmadm/scfmail server server-name1[,server-name2] rootaddr to-address fromaddr from-address
/usr/sbin/FJSVmadm/scfmail pop pop-server:pop-user:pop-passwd[:waiting-time]]
/usr/sbin/FJSVmadm/scfmail test

DESCRIPTION

The scfmail configures the XSCF mail report. The scfmail actions are controlled by the subcommand argument.

SUBCOMMANDS

The following subcommands are supported:

{enable|disable}

Changes the availability of the XSCF mail report.
If enable is specified, the mail report function is enabled.
If disable is specified, the mail report function is disabled.

server server-name1[,server-name2] rootaddr to-address fromaddr from-address

Specifies the SMTP server and e-mail addresses used for the mail report.
The SMTP server name or IP address is specified for server-name1 and server-name2.
The to-address specifies the destination e-mail address. The e-mail address should be specified in the form of "user@domain". To use two or more addresses for a destination, specify the addresses delimited by the comma. Up to 8 addresses can be specified for the destination.
The from-address specifies the sender address of the e-mail. The specified address is used as a "From" value of e-mail header.

pop pop-server:pop-user:pop-passwd[:waiting-time]]

Configures the POP before SMTP authentication of mail report. When the POP before SMTP authentication is not used, this subcommand need not be used.
The pop-server specifies the server of POP authentication. The pop-user specifies the username for POP authentication. The pop-passwd specifies the password of POP authentication. The waiting-time specifies the transmission waiting time after the authentication of POP. Waiting time is specified by the value of each millisecond of 500 carving from 500 to 127500.

test

Executes the test mail transmission.

EXIT STATUS

The scfmail command exits with one of the following values:
0 Success.
>0 An error occurred.

NOTES

Please confirm e-mail sending can be correctly done by using the "test" subcommand whenever the setting of the report is changed by this command.