Enhanced Support Facility 2.6 User's Guide

3.8 rcihello(1M)

NAME

rcihello - Controls CHECK LEDs of units connected via RCI

SYNOPSIS

/opt/FJSVhwr/sbin/rcihello { on | off } [ address ]

AVAILABILITY

FJSVscu

DESCRIPTION

rcihello controls CHECK LEDs of units connected via RCI

The following models can use this command.

• GP7000F model 200/200R/400/400A/400R/600/600R
• PRIMEPOWER 200/400/600/650/850

OPTIONS

The following options are available:

Address

Specifies units to be controlled, which are connected via RCI. If no address is specified, all of the units connected via RCI will be controlled. Addresses are given in 8-digit hexadecimal.

on

Blinks CHECK LEDs

off

Stops blinking CHECK LEDs

EXAMPLES

# rcihello on 003001ff

NOTES

The off option does not necessarily turn off CHECK LEDs. The CHECK LEDs with the addresses, which you did not specify to blink on the rcihello command line, reflect the internal status of the units connected via RCI.
Where old information remains on RCI devices that were previously connected, but currently are not, rcihello executed with no address (control for all of the units connected via RCI) will display error messages.
In this case, you must reconfigure RCI setting.
Note that only the super user can execute this command.

For the model by whom this command is not offered, "Machine Administration" offers the function equal with this command. Please refer to Machine Administration Guide".

EXIT STATUS

This command returns the following values:

0

Ended normally

>0

Error

SEE ALSO

rciinfo(1M), rcinodeadm(1M)