Enhanced Support Facility 2.6 User's Guide

3.2 hsadm(1M)

NAME

hsadm - Supports hot-swapping of internal power units and fans

SYNOPSIS

/opt/FJSVhwr/sbin/hsadm action unit

AVAILABILITY

FJSVscu, FJSVlscu

DESCRIPTION

hsadm supports the hot-swapping of internal power units and fans.
This command displays the state of power supplies and fans and starts/stops the monitoring feature for both of those devices.
The command line must contain one action and at least one unit.
You can specify display, enable, or disable for action.
You can specify power and/or fan for unit.

The following models can use this command.

• GP7000F model 200/200R/400/400A/400R/600/600R
• PRIMEPOWER 1/100/200/400/600

EXAMPLES

action

display unit

Displays the status of the specified unit. The following shows the display format:

Power unit:
     Monitoring Mode: On / Off
         FEP#0  State: Okay / Needs maintenance
Fan unit:
     Monitoring Mode: On / Off
         FAN#0  State: Okay / Needs maintenance

disable unit

Stops the monitoring feature for all specified units.

enable unit

Restarts the monitoring feature for all specified units.

EXIT STATUS

This command returns the following values:

0

Ended normally

1

Error

NOTES

While hot-swapping a power supply, hsadm(1M) command does not display the state of the power supply which is removed.
After hot-swapping power supplies, use hsadm(1M) command to confirm that all of the power supplies which are installed are in state Okay.
Note that only the super user can execute this command.