PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Linux)
Contents Index PreviousNext
Chapter 3 Environment configuration> 3.5 Deleting configuration information

3.5.2 NIC switching mode

The following shows the procedure for deleting configuration information:

  1. Stop the HUB monitoring function using the "hanetpoll off" command. For information, see "7.7 hanetpoll Command".
  2. Inactivate the virtual interface of the concerned NIC switching mode using the "stphanet" command. To delete the operated definition in a cluster system, deactivate a virtual interface of the standby patrol using "stpptl" command (only when using a standby patrol function). For information, see "7.3 stphanet Command" and "7.11 stpptl Command".
  3. Delete the concerned monitoring destination information. For information, see "7.7 hanetpoll Command".
  4. Delete the configuration information of the concerned virtual interface. For information, see "7.1 hanetconfig Command".
  5. Delete the subnet mask information of the concerned virtual interface using the "hanetmask delete" command. For information, see "7.5 hanetmask Command".
  6. Reboot the system.
Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005