PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Linux)
Contents Index PreviousNext
Chapter 3 Environment configuration> 3.3 Additional system setup

3.3.3 Setting parameter for individual mode

See the following procedure for using a value different from the default value indicated in section "3.1.2.3 Configuration of individual mode".

  1. Use "hanetparam" command and "hanetpoll on" command for setting up the common parameter.
    For detailed description regarding these commands, see "7.6 hanetparam Command" or "7.7 hanetpoll Command".
  2. Reboot the system.
Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005