PRIMECLUSTER Installation and Administration Guide 4.1 (for Linux)
|
Contents
Index

|
8.7.2 Deleting the Hardware Resource
This section explains how to delete the resources of the following hardware.
- Shared disk device
- Network interface card
Procedure
- Stop RMS.
If RMS is activated, stop RMS as explained in "Stopping RMS."
- Delete the hardware resource.
Use "cldelrsc" command to delete the hardware resource that was registered.
See the relevant manual pages for details on this command.

- If you have deleted an available network interface card by mistake, reregister the resources for the accidentally deleted network interface card by executing the "clautoconfig" command.
- If you have deleted other than the correct network takeover resource, reregister the deleted network takeover resource. See "Associating Resources to a Cluster Service Instance."
- If the shared disk for which resources are to be deleted is registered to a GDS class, first delete the shared disk from the GDS class, and then delete the resources of the shared disk. For instructions on how to delete a shared disk from a GDS class, refer to the "PRIMECLUSTER Global Disk Services Configuration and Administration Guide."
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005