PRIMECLUSTER Installation and Administration Guide 4.1 (for Linux)
Contents Index PreviousNext

Part 2 Installation> Chapter 4 Preparation Prior to Building a Cluster> 4.3 Preparations for Starting the Web-Based Admin View Screen> 4.3.3 Initial Setup of Web-Based Admin View

4.3.3.2 Confirming Web-Based Admin View Startup

This section describes the procedure for confirming whether Web-Based Admin View has been started

mark2Confirmation Procedure

Check that all node information is output by executing the "wvstat" command on the connected management server.

(Example)

In a two-node configuration consisting of node1(10.20.30.40) and node2(10.20.30.41), node1 is the primary management server and node2 is the secondary management server.

  # /etc/opt/FJSVwvbs/etc/bin/wvstat
  primaryServer   10.20.30.40 node1  http=10.20.30.40     Run  3m41s
  primaryServer   Sessions: 0
  primaryServer   Nodes: 2
          10.20.30.40 node1      Linux-2.4.9-e.8enterprise       3m36s
          10.20.30.41 node2      Linux-2.4.9-e.8enterprise       2m58s
  secondaryServer 10.20.30.41 node2  http=10.20.30.41     Run  2m46s
  secondaryServer Sessions: 0
  secondaryServer Nodes: 2
          10.20.30.40 node1      Linux-2.4.9-e.8enterprise       2m41s
          10.20.30.41 node2      Linux-2.4.9-e.8enterprise       2m23s
  #

If the information is not properly displayed, Web-Based Admin View has not been started or there may be an error in the Web-Based Admin View settings. Restart Web-Based Admin View and execute the operation again. If node information is still not displayed, refer to the "PRIMECLUSTER Web-Based Admin View Operation Guide" and check the parameter settings.

For details on the "wvstat" command, see the manual page.


Contents Index PreviousNext

All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005