PRIMECLUSTER Installation and Administration Guide 4.1 (for Solaris(TM) Operating System)
Contents Index PreviousNext
Part 4 System Configuration Modification> Chapter 9 Expanding the Operation Configuration> 9.1 Adding a Node

9.1.8 GFS Shared Settings

If the GFS shared file system is used in an existing node, set up the GFS shared file system on the new node by using the following procedure:

mark2Procedure

  1. Execute sfcumntgl for the entire GFS shared file system on any one of the cluster nodes, and then unmount the file system.
  2. Execute sfcfrmstop, and then stop the GFS daemon on all cluster nodes.
  3. Execute sfcsetup on the new node, and then register the node information in the management partition.
  4. Execute sfcfrmstart and then start up the GFS daemon on all cluster nodes.
  5. Execute sfcnode on any one of the cluster nodes, and then add the node configuration information of the new node.
  6. Create a mount point and set up /etc/vfstab on the new node.
  7. Execute sfcmntgl on any one of the cluster nodes and then mount the GFS shared file system.

For information on how to use each command, see the "PRIMECLUSTER Global File Services Configuration and Administration Guide."
Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005