PRIMECLUSTER Installation and Administration Guide 4.1 (for Solaris(TM) Operating System)

8.9 Deleting the Hardware Resource

Delete the hardware resource that was registered with the automatic configuration facility using the following procedure.

Procedure

1. Stop RMS.

   If RMS is activated, stop RMS as explained in "Stopping RMS."

2. Delete the hardware resource.

   Use each command to delete the hardware resource that was registered with the automatic configuration facility.

   See the relevant manual pages for details on each command.

   Resource	Command
   Shared disk device	cldeldevice(1M)
   Network interface card	cldelrsc(1M)
   Line switching unit	cldelswursc(1M)

• If you have deleted an available network interface card by mistake, reregister the resources for the accidentally deleted network interface card by executing the "clautoconfig(1M)" command.
• If you have deleted other than the correct network takeover resource, reregister the deleted network takeover resource. See "Associating Resources to a Cluster Service Instance."