PRIMECLUSTER Installation and Administration Guide 4.1 (for Solaris(TM) Operating System)

5.1.2.1 Checking Console Configuration

Check the configuration information on the console (RCCU or XSCF) to be used.

• Check the console information before initially configuring the cluster system.
• Set the IP address of RCCU or XSCF to the same segment as the administrative LAN.

Checking RCCU

If RCCU is used for the console, record the following information on RCCU. Note, however, that you do not need to record if you use the console with the factory settings.

• RCCU IP address or a RCCU host name registered in the "/etc/inet/hosts" file
• User name to log in the RCCU control port
• Password to log in the RCCU control port
• Password to log in the RCCU control port using superuser access privileges.

For details on how to configure and check RCCU, see the instruction manual provided with RCCU.

Checking XSCF

If you use XSCF, check the following:

• The standard console has the SCF-LAN port.
• Only the Read console port is enabled in XSCF telnet ports.
• The XSCF shell port (hereafter referred to as the control port) is enabled in the XSCF telnet ports.
• The group ID of a user account to log on to the control port is root.

Correct settings as described above if necessary.

Record the following information on XSCF.

• XSCF IP address or an XSCF host name registered in the "/etc/inet/hosts" file
• User name used to log in the XSCF control port (*1)
• Password used to log in the XSCF control port

*1) The group ID of a user account must be root.

For information on how to configure and confirm XSCF, see the "XSCF (eXtended System Control Facility) User's Guide."