PRIMECLUSTER Global Disk Services Configuration and Administration Guide 4.1 (Linux)

H.4.1 clautoconfig(8)-Execute automatic resource registration

SYNOPSIS

/etc/opt/FJSVcluster/bin/clautoconfig -f diskfile

/etc/opt/FJSVcluster/bin/clautoconfig -r -n

 

DESCRIPTION

This command enters information of the following hardware connected to a cluster system in the resource database.

• Shared disk devices

  Information of shared disk devices specified in the shared disk file is entered in the resource database.

• Network devices

  Network devices are automatically detected and entered in the resource database.

You can execute this command on any single node in the cluster system with the Administrator's authority.

While this command is running, you may not execute this command on the given node or another node.

 

OPTIONS

-f diskfile

Registers the shared disk unit in the resource database. Specify the definition file for diskfile by full path.

 

-n

Registers the network device in the resource database. The detected network device is active. The inactive devices are not detected. Execute the ifconfig(8) command to confirm if the network device is running.

 

-r

Registers the resource automatically.

 

EXIT STATUS

0:

Normal termination.

Other than 0:

Abnormal termination.

 

NOTES

You need to check the following before executing the command:

• Setup of CF, CIP and resource database are done on all nodes
• All nodes are connected to the shared disk units.
• All nodes start in a multi-user mode.