Enhanced Support Facility 2.5.1 User's Guide

11.4.9 Checking on Command Completion

The setup_license command checks the license registered in a license file on completion. The contents shown below are checked.

1) Validity of the license password

2) Valid term

A license password will be checked, to ensure incorrect contents are not input by the user. If the license server has been registered / deleted once, the license password will not be recognized as the correct password.

Normally, it is not necessary to check a license password because an unlimited license password (1-jan-0) is issued. But sometimes, a limited license password is issued where software is only for temporary use.

On completion, the result of the check (as shown below) is displayed when a failure is detected. If no failure is detected, no message is displayed.

The license file is invalid.
fn4 0BDAC011E677790223FD 1-jan-0 Bad Password
fn5 1BDA10E173D1F8E68D6A 1-apr-99 Expired

The contents are displayed in the following format.

Feature name License password Valid term Contents