The management scope varies depending on the resources used by the configured physical server or virtual machine.
Depending on which resources can be managed, L-Servers are referred to differently as follows:
L-Server for Server Management
Refers to L-Servers that operate only servers.
For physical servers
This applies when using the hardware listed in "18.3.1 Manageable Hardware".
For Virtual Machines
This applies when using a physical server and when using server virtualization software.
The hardware listed in "18.3.1 Manageable Hardware" and "18.3.3 Manageable Storage"
The server virtualization software described in "18.3.4 When Using Server Virtualization Software"
L-Server for Server/Storage Management
Refers to L-Servers that operate servers and disks.
For physical servers
This applies when using the hardware listed in "18.3.1 Manageable Hardware" and "18.3.3 Manageable Storage".
For Virtual Machines
This applies when using a physical server and when using server virtualization software.
The hardware listed in "18.3.1 Manageable Hardware" and "18.3.3 Manageable Storage"
The server virtualization software described in "18.3.4 When Using Server Virtualization Software"
[Solaris Containers]
For Solaris Containers, only the "L-Servers for server management" are supported.
Note
When linking a configured physical server to a physical L-Server, only "L-Server for server management" is supported. "L-Server for server/storage management" cannot be created.
When disk and NIC information is successfully obtained from the configured physical server or virtual machine, that information is displayed. The output information for NICs differs depending on the L-Server type.
For Physical L-Servers
MAC address, IP address (only for admin LAN)
For Virtual L-Servers
MAC address (Media Access Control address)
When admin server has been configured on a virtual machine, do not link that virtual machine to an L-Server.
