Specify the following items.
Configure the network to connect with the NIC used in the L-Server. Clicking <Add> displays the [Add a Network] dialog. Select a network resource to connect with the NIC.
The number of NICs that can be configured is 1 to 32.
Select the NIC to use in the L-Server from the selection list. When adding a new NIC or NIC group, select the number displayed as "(Undefined)" from the list. When selecting an already defined NIC, a network resource is added.
When performing NIC redundancy, check the [Setup redundant NIC] checkbox, and select another NIC pair from the list to make redundant.
Select a network resource to connect.
Clicking <Delete> deletes the selected network.
Clicking <Change> displays the [Select a Network Resource] dialog.
If <OK> is clicked while a network resource is selected, the network resource to connect is modified.
Specify the IP address to allocate to the L-Server. This should be entered for direct specification of the IP address to be allocated to the L-Server. The specified IP address will be converted to the IP address of the physical server during creation of the L-Server.
Note
If a LUN created beforehand is used to create a physical L-Server, specify the IP address of the OS stored in the LUN.
If an agent has already been installed in the LUN created beforehand, and the IP address of the manager has been changed, the following procedures need to be performed after creating the physical L-Server.
Initialize the file where the agent's SSL certificate data is stored.
For details, refer to "5.5 rcxadm certctl" in the "Reference Guide (Command/XML) CE".
Modify the IP address of the admin LAN of the manager registered in the agent.
For details, refer to "5.3 rcxadm agtctl" in the "Reference Guide (Command/XML) CE".
Reboot the physical L-Server.
Example
OS Information | Information for L-Server Configuration | ||
---|---|---|---|
IP address specified for network interface (configured by a tenant administrator) | Name of network interface | Number of NICs (number of NICs on the back side of rack mount servers) | IP Address |
192.168.1.1 | Local area connection 1 | 1 | 192.168.1.1 |
192.168.2.1 | Local area connection 2 | 2 | 192.168.2.1 |
OS Information | Information for L-Server Configuration | ||
---|---|---|---|
IP address specified for network interface (configured by a tenant administrator) | Name of network interface | Number of NICs (number of NICs on the back side of rack mount servers) | IP Address |
192.168.1.1 | eth0 | 1 | 192.168.1.1 |
192.168.2.1 | eth1 | 2 | 192.168.2.1 |
When not configuring a VLAN, check this checkbox.
Only one VLAN can be selected in the same NIC or NIC group.
Note
[Physical Servers]
The IP address to be allocated to a physical L-Server must be unique. An IP address is required for each L-Server used.